Filter
Top Products
Living innovation
Cappuccino and
Espresso Coffee Maker
EC11
6
- Once the coffee has reached the required level in the cup, stop
dispensing by moving the lever (7) back to the upright standby posi-
tion (Fig. 7).
If the lever (7) is not moved back to the upright position after use,
small amounts of water and steam may leak out from the coffee
dispensing nozzles for as long as there is water in the boiler tank.
This does not mean that the appliance is malfunctioning. To resolve
this problem,it is sufficient to move the lever (7) to the upright
standby position.
Successive use
- To dispense more coffee immediately after, proceed as follows:
- Unhook the filter holder from the body of the machine and clean
out the coffee grounds from previous dispensing.
- Place the empty water measure under the MAXI CAPPUCCINO
device (3) and release all residual steam inside the boiler by holding
down the steam dispenser button (4) (Fig. 8). With the button
pushed, it is possible to bring the measure forward into its fixed
position, allowing you to take your finger off the steam dispenser
button and simply wait for the remaining residual steam to dischar-
ge.
- When the steam is all out, move the device (3) back to its initial
position, pushing it back with the measure (Fig. 10).
- Unscrew the safety cap to refill the boiler tank and then follow the
steps described here above.
WARNING: :The boiler tank cap is fitted with a safety valve which
allows it to be unscrewed only if all residual steam has been completely
released.
MAKING CAPPUCCINO
To make a cappuccino or hot chocolate, or to heat any other beverage,
proceed as follows:
If the coffee has already been prepared:
- Move the power lever (7) to the pre-heat position (Fig.5). In this
position, the boiler tank remains pressurised without dispensing any
liquid from the nozzles on the filter holder.
- Place the container of milk to be foamed (or liquid to be heated)
under the MAXI CAPPUCCINO device (3) and press the steam but-
ton (4) to start the jet of steam (Fig. 11). While holding down the
button, you can move the MAXI CAPPUCCINO device (3) forwards
using the milk container until it is in the fixed position, allowing you
to remove your finger from the steam button and to wait until the
Fig.7
Fig.8
Fig.9
Fig.10
Fig.11
YOU_ME_DeLonghi.qxp 22-05-2006 15:15 Pagina 6