DeLonghi ECAM23210B/SB Coffeemaker User Manual


  Open as PDF
of 22
 
18
bubbles to escape (fig� 31)�
5� Insert the filter in the filter housing (fig� 32A)
and press as far as it will go�
6� Close the tank with the lid (fig� 32B), then
replace the tank in the machine�
When you install the filter, you must notify the
appliance of its presence�
7. PresstheP button to enter the menu;
8� Turn the selection knob until the and
lights come on�
9. Pressthe OK button�
10.Pressthe button to confirm the selec-
tion�
11.Placeacontainer(min.capacity:100ml)un-
der the cappuccino maker�
12� Turn the steam knob and press the but-
ton�
13� At the end of delivery, the light flashes�
Close the knob and the appliance returns au-
tomatically to the “ready for coffee” state�
The new filter is active and you can now use the
coffee maker�
Replacing the filter
When the light flashes, after two months
(see date indicator) or when the appliance has
not been used for 3 weeks, you should replace
the filter:
1� Remove the old filter;
2� Remove the new filter from the packaging�
3� Turn the date indicator disk (see fig� 30) until
the next 2 months of use are displayed (the
filter lasts about two months);
4� Refill the tank;
5� Insert the filter in the water tank and immer-
se it completely, sloping it to enable the air
bubbles to escape (fig� 31);
6. Placethelterinthelterhousing(g.32A)
and press as far as it will go� Close the tank
with the lid (fig� 32B), then replace the tank
in the machine;
7. Placeacontainer(min.capacity:100ml)un-
der the cappuccino maker�
8. PresstheP button to enter the menu;
9� Turn the selection knob until the and
lights come on�
10.Pressthe button� The OK light flashes�
11.Pressthe button to confirm the selec-
tion�
12� Turn the steam knob and press the
button�
13� At the end of delivery, the light flashes�
Close the knob and the appliance returns au-
tomatically to the “ready for coffee” state�
The new filter is now active and you can use the
coffee maker�
Removing the filter
If you want to continue using the appliance wi-
thout a filter, you must remove it and notify the
appliance of its removal as follows:
1� Extract the tank and exhausted filter;
2. Pressthe P button to enter the menu;
3� Turn the selection knob (fig� 8) until the
and lights come on;
4. Pressthe button� The OK light flashes;
5. Pressthe button to confirm use of the
appliance without the filter;
6. Pressthe button to exit the menu�
TECHNICAL SPECIFICATION
Voltage: 120V~ 60Hz
Absorbed power: 1350W
Pressure: 15bars
Water tank capacity: 50�7 fl� oz� max�
Size LxHxD: 2,38x3,4x4,3 in�
Cable length: 11 ft�
Weight: 20,22 lb�
Coffee beans container capacity: 5,3 oz� max�
 previous next