Filter
Top Products
MAX
level
fig. 1
fig. 2
fig. 3
fig. 4
Electric Deep Fryer F455CZ
3
Thank you for choosing this deep fryer.To get the best results
from your deep fryer it is advisable to read these instructions
before using the appliance. This is the only way to ensure
optimum results and maximum safety.
Installation
• Before use, check that the appliance has not been damaged
during transport.
• Remove the appliance from the packaging, including any p.o.s.
• Before use, check that the power supply voltage corresponds
to the value shown on the appliance rating plate.The appliance
must always be connected to a well earthed socket rated at
10A minimum.The manufacturer is not liable for damage
caused by inadequate earthing of the appliance.
• Before using the deep fryer for the first time, carefully clean the
basket, the bowl, the casing and the lid, using warm water and dish-
washing detergent. The control unit, power cable and heating ele-
ment may be cleaned using a damp cloth. Check that water does
not enter into the control unit and that there is no residual water
in the bottom of the removable bowl. Carefully dry all the parts.
• Check that the control unit is properly fastened to the deep fryer
body.The safety micro-switch will not allow the appliance to be
operated if the control unit is not correctly positioned in the casing.
• Place the fryer on a flat work surface at a safe distance from taps
and sinks.
• The deep fryer is now ready for use.
Thermal safety device
The appliance is fitted with a thermal safety device that stops the
appliance from heating in the event of incorrect use or irregular opera-
tion. Once the appliance has cooled, using a toothpick or something
similar,delicately press the safety device reset button marked RESET
(see Fig. 1). If the appliance does not start operating again, contact a
service centre authorised by the manufacturer.
Using the fryer
• Remove the lid lifting it by the handle.Turn the folding handle of the
basket until it locks into place (pos. 2, Fig. 2). Remove the basket by
lifting it upwards.
• Remove the length of cable required to connect the appliance to the
mains, from the cable compartment (see Fig. 3).
•Pour 4 litres of oil into the bowl until reaching the maximum level
indicated (see Fig. 4). For best results, use good quality oil. Avoid
mixing different types of oil.
If using lumps of solid fat, cut them into small pieces so that the deep
NO!
fig. 5
F455UK 5-09-2003 9:19 Pagina 3