DeLonghi KBE3014-2 Hot Beverage Maker User Manual


 
Thank you for choosing this De’Longhi kettle.To get the
best results from your new kettle it is advisable to read
these instructions carefully before using the appliance.
This is the only way to ensure optimum results and maxi-
mum safety.
Before use
Check that the appliance has not been damaged during trans-
port.
Remove all packaging from the kettle and power base.
Remove any labels from the outer surfaces.
Remove the filter (fig. 1) and wash with water (fig. 2). Refer to
page 5.“Removing the scale filter”
Fill the kettle and boil.
The boiled water should be discarded and the kettle rinsed out
with cold water.This procedure should be carried out three
times, to remove any manufacturing dust, etc.
•After the kettle has been rinsed out, re-fit the filter (fig. 3).
Using the kettle
Power base with 360° access
With the specially designed power base and central connector,
you can now set the kettle on the base at any angle, from any
position.
Release cord from storage base and adjust length by winding
around the base to give the correct cord length to reach the
plug socket to be used (fig. 4).
Do not leave loose cord hanging over the edge of work sur-
faces.
Filling
Remove the kettle from the base unit before filling.
Open lid and fill kettle to desired level.
Do not fill with less than 0,5 litre of water to prevent the ket-
tle running dry while operating; misuse of this kind will shorten
the life of the element.
Do not fill with more than 1,7 litres of water (up to the MAX
indication located inside the kettle) (fig. 5). If the kettle is over-
filled, there is a risk that boiling water may overflow and cause
burns.
A handy external water level indicator enables you to see the
quantity of water in the kettle.
Kettle
3
a
c
b
1
2
Fig.1
Fig.2
Fig.3
Fig.4
CORD EXIT
Fig.5
MAX 1.7 litres
MIN 0.5 litres
MAX 1.7 litres