Filter
Top Products
1771018IDL/03.10
De’Longhi Appliances - Via L. Seitz, 47 - 31100 Treviso Italia
Electrical requirements
Before using this appliance ensure that the voltage indicated on the
product corresponds with the main voltage in your home, if you are
in any doubt about your supply contact your local electricity com-
pany.
The flexible mains lead is supplied connected to a B.S. 1363 fused plug hav-
ing a fuse of 13 amp capacity. Should this plug not fit the socket outlets in
your home, it should be cut off and replaced with a suitable plug, following
the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should there-
fore be properly disposed of and not left where children might find it and
plug it into a supply socket - with the obvious consequent danger.
N.B.We recommend the use of good quality plugs and wall sockets that can
be switched off when the machine is not in use.
important: the wires in the mains lead fitted to this appliance are coloured in
accordance with the following code:
As the colours of the wires in the mains lead of this appliance may not cor-
respond with the coloured markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured green and yellow must be connected to the ter-
minal in the plug which is marked with the letter E or by the earth symbol
or coloured green or green and yellow.
The wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which
is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are securely retained in
each terminal. Do not forget to tighten the mains lead clamp on the plug. If
your electricity supply point has only two pin socket outlets, or if you are in
doubt, consult a qualified electrician.
Should the mains lead ever require replacement, it is essential that this oper-
ation be carried out by a qualified electrician and should only be replaced
with a flexible cord of the same size.
After replacement of a fuse in the plug, the fuse cover must be refitted. If the
fuse cover is lost, the plug must not be used until a replacement cover is
obtained. The colour of the correct replacement fuse cover is that of the
coloured insert in the base of the fuse recess or elsewhere on the plug.
Always state this colour when ordering a replacement fuse cover. Only
13amp replacement fuses which are asta approved to B.S. 1362 should be fit-
ted. This appliance conforms to the Norms EN 55014 regarding the sup-
pression of radio interference.
Warning - this appliance must be earthed
GREEN AND YELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE
Green and Yellow to Earth
Blue to
Neutral
13 amp
Fuse
Brown
to Live
Cord Clamp