Delta SIG110DL Ventilation Hood User Manual


 
DELTA ELECTRONICS THREE YEAR LIMITED WARRANTY
Delta Electronics Inc. (“Delta Electronics”) warrants to the original consumer purchaser in
the USA that the Breez ventilation fan products will be free from defects in material or
workmanship. This warranty is limited to three (3) years from the original date of purchase.
Limitations and Exclusions
1. During the warranty period, a replacement for any defective product will be supplied free
of charge for installation by the consumer. The warranty provided herein does not cover
charges for labor or other costs incurred in the troubleshooting, repair, removal, and
installation service.
2. All returns of defective parts or products must include the product model number, and
must be made through an authorized Delta Electronics distributor. Authorized returns must
be shipped prepaid. Repaired or replacement products will be shipped by Delta Electronics
F.O.B. shipping point.
3. Delta Electronics shall not be liable for any indirect, incidental, consequential, punitive, or
special damages arising out of or in connection with products use or performance,
regardless of the form of action whether in contract, tort (including negligence), strict
product liability or otherwise.
4. This warranty does not extend to uorescent lamp starters and tubes.
5. The warranty does not cover if user does not comply with manufacturer’s installation
manual.
6. To qualify for warranty service, you must notify Delta Electronics at the address or
telephone number below.
7. Delta Electronics shall have no liability to the original owner-user with respect to any
defect caused by abuse, misuse, neglect, improper transportation or storage, improper
testing, improper installation, improper operation, improper use, improper maintenance,
improper repair, improper alteration, improper modication, tampering or accident of
products or parts thereof, or unusual deterioration or degradation of products or parts
thereof due to a physical environment beyond the requirements of products’ specications.
Address: 4405 Cushing Parkway, Fremont, CA 94538
US Toll Free Number: 1-888-979-9889
MODELS
SIG80L / SIG110L / SIG110HL / SIG110D
L
Page 5.
Factory setting: low speed airow 40CFM, humidity 60%RH.
Dual Speed Models: SIG110DL
5-5. Low speed control mode: Turn the POWER switch on
(MODE switch is o) to operate at the user-adjustable low
speed airow - the LED will be green.
5-6. Full speed control mode: Turn both the POWER switch &
the MODE switch on to operate at full speed mode (LED
indicator will be amber). When the user turns the MODE
switch o, the fan will continue to run at full speed
until
the user-adjusted time delay has elapsed. The fan will
then automatically change to the user-adjusted low
speed airow. The LED indicator will be green.
Factory settings: low speed airow at 40CFM, time delay at 15
minutes.
MAINTENANCE WARNING:
Disconnect the power source before working on the unit.
Routine maintenance must be done every year.
CAUTION:
1. Never use gasoline, benzene, thinner or any other such
chemicals to clean the ventilating fan.
2. Do not allow water to e
nter the motor.
3. Do not soak resin parts in water over 60°C (140°F).
CLEANING
1. Open lens cover. Remove the light bulbs carefully.
Disassemble the lock screw, lock nut and light power
connections to remove grille.
2. Wash and clean grille. CAUTION: Do not let water into the
lamp base. (Use a non-abrasive kitchen detergent and
wipe dry with a clean cloth.)
3. Remove dust and dirt from the ventilating fan.
4. Using a cloth dampened with non-abrasive kitchen
deter
gent, remove any dirt from ventilating fan. Wipe dry
with a clean cloth.
5. Replace the grille.
DIMENSIONS
SPECIFICATIONS
Model No.
Voltage
(V)
Frequency
(Hz)
Air Flow
@ 0.1” SP
(CFM)
Weight
(lb.)
Power
(W)
Note
SIG80L 120 60 80 10.7 48.0 Single Speed
SIG110L 120 60 110 10.7 53.0 Single Speed
SIG110HL 120 60 110 10.7 53.0 Humidity Sensor
SIG110DL 120 60 110 10.7 53.0 Dual Speed
Note: Design and specications subject to change without notice.
WARRANTY