Filter
Top Products
www.desatech.com
117190-01B
4
GROUNDING
INSTRUCTIONS
This stove is for use on 120 volts. The cord has a
plug as shown in Figure 2. An adapter is available
for connecting three-blade grounding-type plugs
to two-slot receptacles. The green grounding lug
extending from the adapter must be connected to
a permanent ground such as a properly grounded
outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
Figure 2 - Grounding Methods
Figure 3 - Electric Stove Control Panel
OPERATING
INSTRUCTIONS
Once the unit has been properly connected to a
ground electrical outlet, it is ready to operate.
Note: Ensure the circuit breakers for power
supply are turned on.
CONTROL PANEL OPERATION
Controls are located on the back of the unit
(see Figure 3).
1. Main ON/OFF power switch: This switch is
located at the furthest right corner on the
control panel when looking at the back of
the unit. Turn the switch to ON and unit
will be ready to operate. The "|" indicates
ON and "O" indicates OFF.
IMPORTANT: Once you turn
the main switch to the ON posi-
tion, the remote control can no
longer be used. In order to use
the remote control, you must
keep the main ON/OFF switch
in the OFF.
2. Display ON/OFF Dial: There is a flame icon
directly below this dial and it is the knob
at. After you turn the Main Power switch
to the ON position, turn the Display Dial
to desired setting. Both the logset and the
flame will light up inside the fireplace
3. Heater Switch and Control Dial: The heater
switch has a sun directly below it. To turn the
heater on, flip the Heater Switch to ON position
(the "|" indicates ON and "O" indicates OFF).
The Control Knob has a thermometer below
it. Turn the dial clockwise past the number 8.
You should hear a small clicking sound indicat
-
ing the heater has started and heat will emit
through vents located at the bottom of the unit.
To turn off heater, turn the temperature dial
counter clockwise past number 1 and flip the
Heater Switch to OFF position. Heat will stop
coming out of the vent.
To increase the desired temperature, turn
the temperature dial clockwise towards
Number 8.
To decrease the desired temperature, turn the
temperature dial counter clockwise towards
number 1. The heater has a built-in thermo
-
stat so it will shut off automatically once the
set temperature is reached. It will also turn on
automatically if the room temperature drops
below the set temperature on the dial.
Note: When the heater is turned on for the
first time, it may release a slight, harmless
odor. This odor is a normal occurrence caused
by the initial heating of the internal heating
elements and should not occur again.
4. Flame Control Dial: This dial controls the
intensity of the flame.
OPERATING BY REMOTE CONTROL
1. Plug in your electric fireplace and it will
beep once. This means you have power
and your remote is ready to operate your
electric fireplace.
IMPORTANT: To control the
electric fireplace by remote, the
Main ON/OFF power switch on
the fireplace must be in the OFF
position; the remote control will
NOT work if the manual ON/OFF
switch is in the ON position.
Display Dial
Main Power SwitchFlame Control Dial
Heater Switch
Heat Control Dial
Grounding Pin
Adapter