Filter
Top Products
112127-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
3
3
SAFETY INFORMATION
PRODUCT IDENTIFICATION
5. This stove reaches high temperatures. Keep children and adults
away from hot surfaces to avoid burns or clothing ignition. Stove
will remain hot for a time after shut-down. Allow surfaces to
cool before touching.
6. Carefully supervise young children when they are in the room
with stove.
7. Do not modify this stove or burner system under any circum-
stances. Any parts removed for servicing must be replaced prior
to operating burner system.
8. Turn burner system off and let cool before servicing, installing,
or repairing. Only a qualified service person should install, ser-
vice, or repair this stove or burner system. Have stove and burner
system inspected annually by a qualified service person.
9. You must keep control compartments, burners, and circulating air
passages clean. More frequent cleaning may be needed due to
excessive lint and dust from carpeting, bedding material, pet hair,
etc. Turn off the gas valve and pilot light before cleaning stove or
burner system.
10. Have venting system inspected annually by a qualified service
person. If needed, have venting system cleaned or repaired.
See Cleaning and Maintenance, page 22.
11. Keep the area around your stove clear of combustible materi-
als, gasoline, and other flammable vapor and liquids. Do not
run burner system where these are used or stored. Do not place
items such as clothing or decorations on or around stove.
12. Do not use this stove to cook food or burn paper or other objects.
13. Never place anything on top of stove.
14. Do not use any solid fuels (wood, coal, paper, cardboard, etc.)
in this burner system. Use only the gas type indicated on burner
system nameplate.
15. This appliance, when installed, must be electrically grounded
in accordance with local codes or, in the absence of local codes,
with the National Electrical Code, ANSI/NFPA 70, or the Ca-
nadian Electrical Code, CSA C22.1.
16. Do not obstruct the flow of combustion and ventilation air in
any way. Provide adequate clearances around air openings into
the combustion chamber along with adequate accessibility
clearance for servicing and proper operation.
17. Do not install stove with burner system directly on carpeting,
vinyl tile, or any combustible material other than wood. The stove
must set on a metal or wood panel extending the full width and
depth of the stove.
18. Do not use stove or burner system if any part has been ex-
posed to or under water. Immediately call a qualified service
person to arrange for replacement of the unit.
19. Do not operate burner system if any log is broken.
SAFETY INFORMATION
Continued
20. Do not use a blower insert, heat exchanger insert, or other ac-
cessory not approved for use with this stove.
21. Do not operate burner system with glass door removed, cracked,
or broken.
22. This heater must be properly connected to a vent system. This
heater is equipped with a vent safety shutoff system.
23. Provide adequate clearances to air openings.
PRODUCT IDENTIFICATION
Figure 1 - DESA B-Vent Burner System Shown Installed in
Approved DESA Cast Iron Stove Body Models SCIVFC,
PSCIVFC,VCIS, PVCIS and VH Series Only (Oxford™ Model
Shown)
Blower with
Adjustment
Knob
(Optional
Installation)
Pilot
Assy
Burner
Vent Opening
Stove
Front
Glowing
Embers
Grate
Assembly
Rear
Cover
Cast Iron
Stove Body
Lava
Rock
P
I
L
O
T
O
F
F
P
I
L
O
T
O
N
H
I
LO
IN
OUT
Cast Iron
Stove Body
Piezo Ignitor Control Valve
Log Set