9
EOS2006
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and heating
element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
CIRCUIT BOARD REPLACEMENT
1. Open door by pulling the handles.
2. Remove the screw from the logset located in the center of the emberbed and remove the
logset from the unit
3. While holding the mirror to prevent it from moving, remove the 2 mirror retaining bracket
screws. Carefully remove the mirror and store in a safe place to prevent damage.
4. Remove the 3 screws securing rear reflector to the unit.
5. Locate the circuit board on the underside of the rear reflector bracket.
6. Remove wiring connections from circuit board noting their original locations.
7. From the underside of the circuit board, break off the 4 mounting studs by grasping with
pliers and twisting on the protruding part of the stud, push the remainder of the studs out
through the top panel.
8. NOTE: New mounting studs are supplied with the replacement circuit board
9. Reassemble in the reverse order as above.