![](http://pdfasset.owneriq.net/4/90/49044726-6229-4124-b996-dafc7438b678/49044726-6229-4124-b996-dafc7438b678-bge.png)
PERIODIC MAINTENANCE
Checking the control system
Checking the connections
supply must be turned on.
connections. The appearance of bubbles indicates a
leak and should be repaired immediately!
Checking the LP gas pressure
readjusted if pressure is incorrect. The correct operating pres-
at the test port, just ahead of the burner jet.
Cleaning the ue bafe and burner
of the burner.
Turn off the refrigerator.
supply to the refrigerator.
Turn off the manual shut off valve.
burner mounting screws and then, the burner as-
sembly.
3.
-
not properly
burner with compressed air.
compressed air.
einstall and tighten the burner jet.
-
couple is positioned properly (tip of thermocouple
extends over two slots of burner).
Turn on the manual gas shut off valve.
non-corrosive bubble solution.)
7.
MAINTENANCE & SERVICE
BURNER TUBE .
SPARK ELECTRODE
BURNER JET
BURNER MOUNTING
SCREWS
PRESSURE TEST PORT
MANUAL SHUT OFF VALVE
(Shown in open position)
INLET FITTING
SOLENOID VALVE
Gas equipment assembly
Electrode
Burner tube
1/8” to 3/16”
(3-5 mm)
4HEFLAMESHOULDBE
CLEARBLUEOVERTHE
SLOTSOFTHEBURNER
FIRE HAZARD. Do not use a wire or pin when
cleaning the burner jet as damage can occur to
the precision opening. Failure to heed this warn-
ing could cause re resulting in personal injury.
WARNING
!
EXPLOSION HAZARD. Never use an open
ame to check for gas leaks. Failure to heed this
warning could cause an explosion resulting in
death or severe personal injury.
WARNING
!