- 7 -
INSTALLATION INSTRUCTIONS
Secure the refrigerator and the lower front strip
with two screws: One screw through the hinge
and on the opposite side and then, one screw
through the lower front strip.
Two screws installed in the top frame.
Remove the top decoration panel.
Open the door.
Gently push the tabs out
of the hole in the hinge
with a fl at blade screw-
driver (both sides).
Carefully tilt the top
decoration panel and
lift to remove from top
frame. Be careful not to
damage the circuit board and wires.
Install the two screws in the top frame, the holes
are accessible from underneath.
Seal the opening for the screws with aluminum
tape.
Replace the top decoration panel. Be careful not
to pinch the wires behind the panel. Make sure
the tabs snap back into the holes in the hinge
plate.
Two screws installed in the rear base.
b)
2.
a)
b)
c)
d)
e)
f)
3.
2
1
DRAIN WATER HOSE
A hole must be drilled through fl ooring and the installer needs
to make sure the hose does not kink when run through the fl oor.
Seal around the hose that goes through the drilled hole. If a
longer hose than supplied is required to get the water to drain
outside of the vehicle, the installer will have to supply the extra
length of hose.
CONNECTIONS
Gas connection
Hook up to the gas supply line is accomplished at the manual
gas valve, which is furnished with a 3/8” SAE (UNF 5/8” -18)
male fl are connection. All completed connections should be ex-
amined for leaks using a solution of liquid detergent and water.
Be very careful when working on or near the gas sys-
tem. Do not use an open fl ame to check for gas leaks!
The gas supply system must incorporate a pressure regulator
to maintain a supply pressure of not more than 11 inches water
column. When testing the gas supply system at test pressures:
> 1/2 psi
- the refrigerator and its individual shutoff valve
must be disconnected from the gas supply piping system.
≤ 1/2 psi
- the appliance must be isolated from the gas
supply piping system by closing its individual manual shut-
off valve.
If detailed instructions on the installation and connection to
the gas supply are required, please contact your dealer or
distributor.
•
•
WARNING
!
Hole for drain water hose
RM2351-2354
Hole for drain water hose
RM2451-2454-2551-2554-
2652-2662-2663-2852-
2862-3862 & NDR1062