Filter
Top Products
OPERATING INSTRUCTIONS
the electronic control to function.
AUTO - AES/AUTO mode
AC and GAS.
Press the AUTO/GAS - AES/AUTO/GAS mode
selector button (if not already on). The illuminated
lamp indicates the selected mode.
(If the CHECK indicator lamp is illuminated, see
REFRIGERATOR OVERVIEW > MODES OF
OPERATION > AUTO MODE - AES/AUTO MODE for
further information.)
GAS mode
GAS operation only.
Press the AUTO/GAS - AES/AUTO/GAS mode
selector button to turn off the AUTO mode (if not
already off).
(Within 45 seconds the burner should be ignited
and operating normally. If not, see REFRIGERATOR
OVERVIEW > MODES OF OPERATION > GAS MODE
for further information.)
DC mode (3-way models only)
-
If necessary, adjust the thermostat by pressing the
Temperature selector button.
(RM2351, RM2451, RM2551, DM2652 &
DM2852: The temperature is controlled by a factory
preset temperature setting.)
•
•
2.
•
•
•
3.
TURNING ON THE CLIMATE CONTROL
DM2652, DM2662, DM2663, DM2852, DM2862, NDM1062 &
NDR1292
Turn the Climate control switch to I (ON).
DM3862, NDM1062 & NDR1292
Press the CLC button. The indicator lamp will
illuminate.
TURNING ON THE LOW AMBIENT CONTROL
NDM1062 & NDR1292
Turn the Low ambient control switch to I (ON).
DM3862, NDM1062 & NDR1292
Press the LAC button. The indicator lamp will
illuminate.
TURNING OFF THE REFRIGERATOR
The refrigerator may be shut off while in any mode of opera-
-
ing the interior light.
If the refrigerator will not be in operation for a period of weeks,
it should be emptied, defrosted, cleaned and the doors left ajar.
The ice trays should also be dried and kept outside the cabinet.
ON
OFF
AC
GAS
CHECK
AES
AUTO
COLD
1
2
3
4
5
COLDEST
CLC
LAC
ON
OFF
AC
GAS
CHECK
AES
AUTO
COLD
1
2
3
4
5
COLDEST
CLC
LAC
The Low ambient control
switch is located beneath
the top decoration panel
that houses the control
panel.
The Climate control
switch is located beneath
the top decoration panel
that houses the control
panel.
STARTUP
FIRE HAZARD. Before lighting the gas burner,
after that the RV has not been used for some
time, please check that the gas path between
the burner jet and the burner tube has not been
obstructed. Failure to heed this warning could
cause a re resulting in personal injury.
WARNING
!
BURNER TUBE .
SPARK ELECTRODE
BURNER JET
BURNER MOUNTING
SCREWS
PRESSURE TEST PORT
MANUAL SHUT OFF VALVE
(Shown in open position)
INLET FITTING
SOLENOID VALVE