Filter
Top Products
• Make sure that your hands are
clean and free from hand cream,
soap or similar, which might leave
a slight taint to the water.
• Remove the kettle from the power
base and ensure kettle is cold.
• Open the lid. Hold the top of the
filter and pull it gentl
y up and out
of the kettle. Rinse it under a tap
whilst softly brushing it with a soft
brush. Rinse the kettle out with
fresh water.
• To replace, align the sides of the
filter with the grooves in the filter
holder, and slide it slowly
downwards and back into place.
AFTER SALES SERVICE
If the kettle is not working correctly,
check that:
• You have followed the
instructions correctly.
• The plug fuse has not blown.
• The main supply fuse/circuit
breaker has not blown/tripped.
GUARANTEE AND
INSTRUCTIONS
F O R D U A L I T
DOME K ET T L E
DUALIT LI MI TE D COUNTY OA K WAY CRAWLEY WEST SUS SE X RH11 7ST
TELEPHONE : +44 (0)
1293 652 500
FAC SI MI LE : +44 (0) 1293 652 555
EMAIL: info
@
dualit.com WEB: www.dualit.com
If the powercord is damaged it must
be replaced by a special cord set
available from Dualit or an
authorised Dualit service agent.
This part should only be refitted
by a competent electrician.
If it still does not work, telephone
the Dualit Customer Helpline on:
+ 44 (0) 1293 652 500 or the
shop where you bought it.
In the USA call Dualit Helpline:
973 623 9370
6 GUARANTEE
Any defect affecting the functionality
of the appliance which becomes
apparent within one year of its
purchase will be corrected by free
repair or replacement provided that
it has been used and maintained in
accordance with the instructions and
has not been abused or misused
in any way.
This warranty does not cover any
consequential damages.
Your statutory rights are not affected.
Safeguards
1
Before Use
2
Care And Cleaning
3
5
How To Use
4
6
Guarantee
After Sales Service
Minimise Scale Build-up
• Empty the kettle after each use;
do not allow water to stand in the
kettle overnight; use filtered water
instead of tap water.
• Descale the kettle regularly, at least
once a month, using a proprietary
brand of descaler. In areas of very
hard water descaling may be
necessary more often.
• When descaling, follow the
instructions on the packet of the
descaler. When descaling has
finished, empty the kettle and rinse it
out numerous times with fresh water,
then refill with freshwater, boil,
and discard boiled water.
Water Filter
Depending upon the hardness of the
water the scale particles that remain
suspended in the water may give a
cloudy appearance. The filter fitted to
your kettle will help prevent these
particles passing into your drink. You
therefore must ensure that the filter is
kept clean and clear of deposits,
otherwise the performance of the filter
may be affected, your drinks may
contain scale and the water inside the
kettle may look cloudy.
• You should clean the filter whenever
there are any obvious deposits left
on the mesh and especially if
pouring is affected.
CARE AND CLEANING
• Switch the kettle off (lift it from the
power base), unplug the power
base from the wall socket, and let
the kettle cool down completely
before cleaning. Wipe the outside
and inside surfaces of the kettle
with a damp cloth.
• If necessary, you may use a little
household detergent. To clean the
filter, see “Water filter” below.
• If you use detergent inside the
kettle, rinse thoroughly afterwards
to remove all traces.
• Ensure that all connectors and
sockets are kept dry.
• Do not immerse the kettle or power
base in water or any other liquid.
• Do not use harsh or abrasive
cleaners or solvents.
Descaling
• Scale build-up will cause the
element to overheat, reducing its
working life. It may also cause the
safety cutout to operate
prematurely, switching the kettle off
before the water actually boils.
•
As the kettle uses an under floor
type element, lime scale can only
build up on the walls and floor of
the kettle, this is readily seen and
should be promptly dealt with.
5
4
6
DDK110506
9088DomeKettle.qxp 5/12/2006 10:28 Page 1
C
M
Y
CM
MY
CY
CMY
K
2006 Dome Kettle_1.pdf 23/8/06 9:46:14 am