Filter
Top Products
• Replacement fuses are available
from Dualit and should be ASTA
approved to BS 1362.
33 HHOOWW TTOO UUSSEE
• Position the power base as close to
a wall socket as possible. Locate
the mains cable so that it does not
overhang the work surface, and
cannot be caught accidentally.
Shorten the mains lead by winding
it around the cord storage area
under the power base, and bring it
out of the cord exit in the base.
OOppeenniinngg tthhee LLiidd
• Remove the kettle from the power
base. If the switch has been
pushed down inadvertently, it will
spring up into the “off” position.
• Hold the kettle handle firmly in one
hand, hold the lid knob in the other,
and pull the lid straight up. As soon
as it separates from the kettle,
move it out of the rising steam.
FFiilllliinngg
• Open the lid and fill the kettle
via the lid aperture. Not through
the spout.
• Observe water level when filling,
you must use at least one cup of
water, but the water level must be
below the Max mark.
• Do not overfill the kettle. If the
kettle is overfilled, there is a risk
that boiling water may be ejected
from the spout and lid.
• Use the kettle only with the power
base supplied and vice versa.
• Do not operate any appliance with a
damaged lead or plug, or after the
appliance malfunctions, or has been
damaged in any manner.
If the mains lead is damaged, it must
be replaced by a special cordset
available from Dualit helpline:
+ 44 (0) 1293 652 500
22 BBEEFFOORREE UUSSEE
• Remove all packaging from the kettle
and its power base. Before using the
kettle for the first time, or if it has been
out of use for a long time, fill to the
max mark and boil, then discard the
boiled water and rinse the kettle out
with fresh cold water.
CCoonnnneeccttiioonn TToo TThhee MMaaiinnss SSuuppppllyy
• Check that the voltage marked on
the appliance corresponds with the
supply voltage.
• NOTE: Any plug cut from power
supply cord should be disposed
of immediately. Inserting any cut
off plug into a 13A socket-outlet
is hazardous.
3
• Never use the plug without the
fuse cover fitted. Ensure replacement
fuse is the same current value as
original.
• Remove the kettle from the power
base before attempting to pour.
• When filling or carrying the kettle,
do not tilt it backwards, as this may
allow water to pass through the
steam tube onto the control area.
Should this happen, the kettle must
be allowed to dry before reuse.
• To avoid the risk of splashing, pour
sslloowwllyy
and do not over-tilt the kettle.
WWAARRNNIINNGG::
IF THE KETTLE HAS
JUST BOILED, IT WILL BE FULL OF
STEAM, WHICH WILL ESCAPE AS
SOON AS THE LID IS OPENED.
BBooiill DDrryy
• Do not switch the kettle on unless it
contains at least one cup of water.
Misuse of this kind will shorten the
life of the kettle.
• If the kettle is accidentally switched
on when it does not contain
sufficient water, a boil-dry device
will automatically switch it off.
Wait until the kettle has cooled
down before refilling. The lid may
be hot and the water may spit as it
touches the kettle base.
• Replace the lid and ensure it is
firmly in place. Check that it is
fully closed, otherwise the kettle
may not switch off when boiling.
SSwwiittcchhiinngg OOnn
• Check that the switch is in the
“Off” position (lift the kettle
from the power base and set it
down again taking care not to
spill any water). The switch will
only operate when the kettle is
correctly fitted onto the base.
• Plug the power base into the
wall socket. If necessary, switch
on the wall socket.
• Press the switch down. The neon
light will light up and the kettle
will start to heat up.
• When the water has boiled the
kettle will automatically switch off,
the switch will return to the “Off”
position and the neon light will
go out.
NNOOTTEE:: WWhheenn yyoouu lliifftt tthhee kkeettttlle
e
ffrroomm tthhee bbaassee,, yyoouu
wwiillll sseeee ddrrooppss ooff mmooiissttuurree
oonn tthhee ssuurrffaaccee ooff tthhee ppoowweerr bbaassee..
TThhiiss iiss tthhee sstteeaamm
uusseedd ttoo sswwiittcchh tthhee kkeettttllee
ooffff aauuttoommaattiiccaallllyy,, wwhhiicchh tthheenn
ccoonnddeennsseess aanndd eessccaappeess vviiaa vveennttss
iinn tthhee uunnddeerrssiiddee ooff tthhee kkeettttllee.. TThhiiss
iiss ppeerrffeeccttllyy nnoorrmmaall,, aanndd sshhoouulldd nnoott
bbee ccaauussee ffoorr aallaarrmm oorr rreettuurrnniinngg
tthhe
e kkeettttllee..
• Do not switch on unless the kettle
contains at least 1 cupful of water.
• Do not allow the mains lead to
hang over the edge of the worktop,
or anywhere it may accidentally be
caught or tripped over.
• Close supervision is necessary when
any appliance is used near children.
• Do not leave appliance unattended
when in use.
• This appliance is not intended for
use by young children or infirm
persons without supervision.
• This kettle is for household
use only.
• Unplug the power base from the
wall socket when not in use,
before moving and cleaning.
Allow the kettle to completely cool
down before cleaning and storing.
• Ensure that the lid is fully closed before
switching the kettle on, otherwise it
may not properly switch off.
• Ensure that the kettle is correctly
placed onto the power base before
switching on.
• Do not fill above the bottom of the
max mark on the water level
indicator. Remove the kettle from its
power base before filling or pouring.
• Do not place the kettle, power base,
or mains lead on or near any hot
surface, hot hob or gas burners.
• Do not use the kettle for any
purpose other than heating water.
Please read these instructions before
using your kettle, keep them in a safe
place for future reference.
Carefully remove all packaging
before use but keep the packaging
until you are satisfied that the kettle is
working correctly.
When using any electrical
appliances, basic safety precautions
should always be followed, including
the following:
• To be protected against electrical
hazards do not immerse the mains
lead, plug, power base, or kettle
in water or any other liquid.
• Do not use in a bathroom or
outdoors.
• Use handles or knobs
. Do not touch
hot surfaces.
• Do not open the lid when the
water is boiling.
• Take care when pouring – pour
slowly, and do not over-tilt the kettle.
• Water will remain hot for a
considerable time after boiling
and can present a scald hazard.
Keep the kettle, power base and
the mains lead away from the
edge of worktops and out the
reach of children.
READ ALL
INSTRUCTIONS
IMPORTANT
SAFEGUARDS
SAVE THESE
INSTRUCTIONS
11
9088DomeKettle.qxp 5/12/2006 10:28 Page 2