EdgeStar PDW45E Dishwasher User Manual


 
8
13. You can select another program during operation by pressing the start/pause key first, then pressing
the program key to the desired program, and pressing the pause/start key again to start the new
program.
14. After washing, dishes should be allowed to cool down for about 15 minutes so they are not too hot to
handle. Dishes will cool more quickly if the door is opened slightly.
15. After unloading the dishwasher, remove the filter, clean off any bits of food, and put the filter back into
place.
NOTE: At the beginning of each cycle, the dishwasher always starts in the “drain” mode. This is because the
drain pump always retains a small amount of water (in the sump) from the previous cycle. This is necessary to
keep the pump primed. Therefore, do not be alarmed if you see a small amount of water being pumped out of
the drain hose prior to the start of the regular wash cycle. This is normal.
Program Summary/Selection
Intensive Wash
Water Temperature: Wash129/Rinse264°F
Program Duration + Heating Time: 125minutes
Water Consumption: 11 quarts
Normal wash::
Water Temperature: Wash125/Rinse152°F
Program Duration + Heating Time: 130 minutes
Water Consumption: 11 quarts
Rapid wash:
Water Temperature: Wash120/Rinse130°F
Program Duration + Heating Time: 70minutes
Water Consumption: 10 quarts
Eco Wash:
Water Temperature: Wash129/Rinse264°F
Programme Duration + Heating Time: 120 minutes
Water Consumption: 11 quarts
Pre-Wash :
Water Temperature: Incoming Water Supply
Programme Duration Time: 12 minutes
Water Consumption: 5.7 quarts
(Note: the washing time may vary according to the incoming water temperature and the ambient
temperature).
Technical Data and Troubleshooting
Technical data
Power input
1160W
Outer dimensions (HxWxD)
17.1”x18.9"x22.5"
Weight
50 pounds
Max. Water Consumption
2.75 gallons
Water pressure
0.03~1MPa
Controls
Digital
Detergent dosage
12g