Filter
Top Products
6
Installation
5 Position the unit to allow free air flow
through the front grille.
6 Wipe out inside of unit with a damp
cloth.
7 Be sure to install the Anti-Tip bracket.
Follow the instructions provided with
the Anti-Tip bracket kit.
Site Preparation
1 Position the unit on a flat, level
surface capable of supporting the
entire weight of the unit. Remember
the unit will be significantly heavier
once it is fully loaded.
2 This unit requires a grounded and
polarized 115 VAC, 60Hz, 15A circuit
(normal household current).
3 Avoid connecting the unit to a Ground
Fault Interrupter (GFI). GFIs are prone
to nuisance tripping which will cause
the unit to shut down. GFIs are
generally not used on circuits which
power equipment that must run
unattended for long periods of time.
4 The unit must be installed according to
your state and local laws and regulations.
WARNING
ELECTROCUTION HAZARD!
Electrical Grounding Required. This
appliance is equipped with a three
prong (grounding) polarized plug
for your protection against possible
shock hazards.
• NEVER remove the round
grounding prong from the plug.
• NEVER use a two-prong
grounding adapter.
• NEVER use an extension cord to
connect power to the unit.
Where a two-prong wall receptacle is
encountered or a longer power cord is
required, contact a qualified electrician
to have it replaced in accordance with
applicable electrical codes.
WARNING
Do not double stack two units
as shown below. This may cause
serious personal injury.
Installing the Anti-Tip
Device
CAUTION
If your wine cooler is not located
under a counter top (free standing),
you must use an anti-tip device
installed as per these instructions. If
the wine cooler is removed from its
location for any reason, make sure
that the device is properly engaged
when you push the wine cooler back
into the original location. If the device
is not properly engaged, there is a
risk of the wine cooler tipping over,
causing property or personal injury if
you or a child stand, sit, or lean on an
open shelf.
CAUTION
Any finished flooring should be
protected with appropriate material to
avoid damage when moving the unit.