Filter
Top Products
Reversing The Door
14
5. Transfer the self-closing system:
Unscrew the self-closing system on the right of the freezer door and
screw it onto the opposite side of the freezer door.
Unscrew the self-closing system on the right of the fridge door and
screw it onto the opposite side of the fridge door.
6. Fit the freezer door into the lower door bearing bolt and insert the cen-
tre door bearing above into the freezer door.
7. Insert the fridge door into the upper door bearing bolt. Pull both doors
forwards until the centre door bearing can be inserted below into the
fridge door.
8. Position the doors and centre door bearing against the housing and
screw the centre door bearing tight with each door open.
9. Fit the plinth cover with the freezer door open. To do this insert the
two lower fins of the plinth cover in the housing and press the plinth
cover against the housing until the upper catches of the plinth cover
snap into position in the housing. To do this, press the catches down-
wards.
After changing the door hinges, check that the magnetic seals on the
doors fit perfectly against the housing and that the interior lighting
goes off when the door is closed.
10. Depending on the model:
Model with bar handle
Unscrew the top handle bracket
from the handle rod (1). Unscrew
the bottom handle bracket from
the door (2).
Unscrew the top handle bracket
from the door (3) and screw onto
the bottom right-hand side of the
door (4).
1
Caution! Do not overtighten the
screws (max. 2 Nm) as you may
damage the door handles.
Turn the handle bracket with the
handle rod 180° and screw them
to the door (5) and the fitted
handle bracket (6).
1
Caution! Do not overtighten the
screws (max. 2 Nm) as you may
damage the door handles.