Filter
Top Products
13
Reversing The Door
The door hinges can be changed from right (as supplied) to left if
required to suit the location where the appliance is installed.
1
Warning! Unplug from the mains, before reversing the door.
0 1. Open the freezer door and with-
draw the plinth cover to the
front. At the same time, press on
the plinth cover from above.
Transfer the door bearing covers
on the plinth cover from left to
right.
2. Unscrew the centre door bear-
ing:
Open the fridge and freezer
doors. Undo the screws far
enough to be able to take the
top door bearing bolt out of
the freezer door. Close the
freezer door. Remove the door
bearing bolt from the bottom
of the fridge door and close
the fridge door.
Caution! Take care when
removing the centre door bear-
ing that the doors do not fall
down.
Remove the centre door bear-
ing; remove the doors and lay
them carefully on the floor.
3. Unscrew the upper and lower
door bearing bolts, transfer,
and screw them onto the
opposite side.
4. Remove the plastic covers for
the centre door bearing and
insert them in the now vacant
holes on the opposite side.