Filter
Top Products
8
ii. By connecting the cooker point to the hob and
then connecting the hob to the oven. Provided
that the hob manufacturer permits it, connect
the oven to the hob to the cooker point using
the same cabling as described in (a) above.
Check the hob terminal block is large enough
to take two cables and is of suitable rating. If
not b) i) on page 7 must be used. See Fig.2.
NOTE: 13 amp cable is not suitable for connecting
this application.
NOTE: It is good practice to:
· Fit an Earth Leakage Circuit Breaker to your
house wiring
· Wire your appliance to the latest IEE regulations.
PREPARING CABINET FOR FITTING OF OVEN
· Make sure the cabinet is the correct size for the
appliance to be fitted (Ref. Fig. 3 and 4).
· If the size is between 565-570mm, then the
cabinet should be modified so that at the screw
fixing points the recommended dimension of at
least 560-565mm is maintained. The
modification should ideally be localised to ensure
that after screw fitment the oven is securely
fixed into position.
· The cabinet must be stable and level by firmly
securing it to the wall or floor. If necessary,
make arrangements to ensure the shelf upon
which the oven will rest is level.
Fig. 2