Filter
Top Products
15
Installation
INSTALLING THE HOOD
First temporarily mount a 2x4 ledger board 30” (762mm) from the finished
countertop. Then, remove the filters from the hood canopy and remove the shields
below the power ventilator. Secure the hood through the keyhole slots in the top of
the hood and/or the slot hole in the rear of the hood. Remove the temporary
support ledger.
Figure 11
Temporary Support Ledger Installation
(9” Shown)
Top
mounting holes
(both sides)
Temporary
support ledger.
Rear
mounting holes
Figure 12
Temporary Support Ledger Installation
(18” Shown)
Top
mounting holes
(both sides)
Temporary
support ledger.
Rear
mounting holes