Electrolux 8290 D Ventilation Hood User Manual


 
15
Wall unit mounting - Fig. 7
Position the template on the wall (1) and mark the position, and drill
(2) the holes (2 x Ø 8 mm).
Mount the two wall plugs with the hooks (3).
Hang the hood on the hooks and level it with the adjustment screws
(4).
Remove the grease filters (5) and mark for the two screws (6).
Remove the hood and drill the holes (2 x Ø 8 mm).
Insert the rawl plugs (7) and hang the hood on the wall again. Adjust
it with the screws (8) and secure it with the screws (9).
Mount the chimney support (10) with the wall plugs (9) and the
screws (11). Be careful that it is centered over the hood and
horizontally aligned.
Extractor version (S): Connect a tube between the hood air outlet
and the wall or roof exhaust channel. Fix it with the tube clamps
supplied.
Filter version (K): Mount the deflector with the two screws supplied
(2,9x13 mm) (13).
Make the electrical connection (14) (see previous page)
Place the chimney (15) and fix it to the top chimney support with the
two screws (16) supplied (2,9x6,5 mm). Lower the bottom part of
the chimney (17) and fasten it to the top of the hood with two
screws, supplied (18) (2,9x6,5 mm).