Filter
Top Products
16
A) End of shaft with nut
B) Washer
C) Elbow
FO 0814
FO 0264
this book be ignored.
On the end of the shaft, which includes the GJ 1/2" threaded elbow,
adjustment is fixed so that the washer is fitted between the components as
shown in the diagram. Screw the parts together without using excessive
force.
It is important to install the elbow correctly, with the shoulder on the
end of the thread, fitted to the hob connecting pipe.
Failure to ensure the correct assembly will cause leakage of gas.
Gas Connection
Connection to the gas supply should be with either rigid or semi-rigid pipe,
i.e. steel or copper.
The connection should be suitable for connecting to RC 1/2 (1/2 BSP male
thread).
When the final connection has been made, it is essential that a thorough leak
test is carried out on the hob and installation.
Ensure that the main connection pipe does not exert any strain on the hob.
Installation