Electrolux Built-In Wall Oven Oven User Manual


 
34
SABBATH FEATURE
(FOR USE ON THE JEWISH SABBATH & HOLIDAYS)
Oven Controls
The HI
+
hi
and LO
-
lo
pads are used to set the Sabbath feature. The Sabbath feature may only
be used with the BAKE
pad. The oven temperature may be set higher or lower after setting
the Sabbath feature (the oven temperature adjustment feature should be used only during Jewish
Holidays), however the display will not visibly show or provide any audible tones indicating
whether the change occurred correctly. Once the oven is properly set using Bake with the
Sabbath feature active, the oven will remain continuously ON until cancelled. This will override
the factory preset 12-Hour Energy Saving feature.
If the oven light will be needed during the Sabbath, press OVEN LIGHT before activating the
Sabbath feature. Once the oven light is turned ON and the Sabbath feature is active, the oven
light will remain ON until the Sabbath feature is turned OFF. If the oven light needs to be OFF,
be sure to turn the oven light OFF before activating the Sabbath feature.
IMPORTANT NOTES: It is not advised to attempt to activate any other program feature other than
BAKE while the Sabbath feature is active. ONLY the following key pads will function after setting
the Sabbath feature;
0
to
9
, BAKE , START , CANCEL , HI
+
hi
and LO
-
lo
.
ALL OTHER KEYPADS will not function once the Sabbath feature is properly activated.
To Program the Upper Oven to Begin Baking Immediately & Activate the
Sabbath feature (example: baking at 350°F)
1. Place the food in the oven.
2. Press OVEN : to light up the available cooking modes pads.
3. Press BAKE .
4. If you desire to set the oven control for a COOK DURATION do so at this time. If not,
skip this step and continue to step 5. Refer to their section for complete instructions.
Remember the oven will shut down after using COOK DURATION and therefore may
only be used once during the Sabbath/Jewish Holidays.
5. Press START .
6. The oven will turn ON and begin heating immediately.
7. Press and hold both the HI
+
hi
and LO
-
lo
pads for at least 3 seconds. SAb will appear in
the oven display. Once SAb appears in the display the oven control will no longer beep or
display any further changes and the oven is properly set for the Sabbath feature.