Filter
Top Products
16
Installing the hood between cupboards with
hanging rails
Remove the grease filters. Fig. 6.
Take off the visor G. Fig. 13.
Mount the two hanging rails directly underneath the edge of
the cupboard using three screws 4,5 x 16 mm in each rail.
Distance from first hole to front edge of the cupboards sides
must be 153 mm. Fig. 8.
Push the extractor hood over the two hanging rails, then fix the hood
from its inside to the cupboards sides with two screws (4,5 x 13)
through the lower holes of the hood. Fig. 9.
Refit the visor. Fig. 13.
Refit the grease filters.
Fit the spacer M on the hood with two screws O and washers,
ensure that there is not a gap between the back of the hood and the
wall by adjusting the spacer M tightly to the wall, using the screws
O. Fig. 11.
153
Fig. 8
Fig. 9