Filter
Top Products
818 20 85-01/2 21
Prior to Initial Start-Up
1
Before connecting the appliance to the mains and putting it into ope-
ration for the first time, leave the appliance to stand for 30 minutes if
it was transported upright. After transport on its side, the appliance
must be left to stand for 2 hours before putting it into operation. This is
necessary to allow the oil to flow back into the compressor. Otherwise
the compressor may be damaged.
0 1. Please clean the appliance interior and all accessories prior to initial
start-up (see section: "Maintenance and Cleaning").
2. Remove the cold accumulation block from the freezer tray.
3. Place the cold accumulation block into a compartment or drawer only
after the optimal storage temperature of -18 °C has been reached, and
allow to freeze.
4. After 24 hours place the cold accumulation block in the freezer tray or
in the front of the upper drawer.
5. Re-freeze the thawed cold accumulation block in the same fashion, e.g.
after cleaning the appliance.