Filter
Top Products
20
TO FIT THE MAIN OVEN SHELVES
The shelves should be fitted with the straight rods
uppermost on the frame and the forms towards the
back of the oven.
To remove a shelf slide the shelf towards you until
the shelf stop is reached. Tilt shelf up at the front so
that the stops clear the side supports. Lift shelf clear.
To install a shelf, reverse the above steps. Each
shelf position has an upper and lower support wire,
ensure the shelf is placed between these two support
wires.
USING THE TELESCOPIC RUNNERS
(where fitted)
1. Ensure the telescopic runners are pushed back
into the oven cavity before fitting the shelf.
2. Holding the front edge of the shelf with both
hands, place the rear shelf forms over the
telescopic runners.
3. Slide the shelf into position, lifting slightly at the
front so that the shelf locates into the retaining
hooks.
To remove, raise the front edge and withdraw the
shelf.
Ensure the shelf is positively located before
using.
Note:
Should you wish to purchase a telescopic runner kit,
this can be ordered from your local Service Force
Centre by quoting part number (BAZ D02).
HINTS AND TIPS
• Arrange the shelves in the required positions
before switching the oven ON. Shelf positions
are counted from the bottom upwards.
• When cooking more than one dish in the fan
oven, place dishes centrally on different shelves
rather than cluster several dishes on one shelf,
this will allow the heat to circulate freely for the
best cooking results.
• When batch baking one type of food, e.g. Victoria
sandwich cakes, those of similar size will be
cooked in the same time.
• It is recommended that when baking larger
quantities the shelf positions should be evenly
spaced to suit the load being cooked. A slight
increase in cooking time may be necessary.
• Do not place baking trays directly on the oven
base as it interferes with the oven air circulation
and can lead to base burning; use the lower shelf
position.
Do not place cookware and cooking pots
with rough bases e.g. cast iron on the oven
door as damage to the glass may occur.
RETAINING
HOOK
FORM