Electrolux DD 8795 Ventilation Hood User Manual


 
68
1
2
3
4
12
14
13
13
10a
10b
11
Fig. 10
Extractor version
Filter version
Fig. 11
Fix the sides of the
cooker hood by
fastening the pins (10a)
to the sides of the
fastening screws (10b).
Only DD 8794 (not UK):
side panels are available
as a special accessory
please contact your local
Service Centre (or see
paragraph Special
Accessory).
Block the sides sliding
the two tabs outwards
(11).
Make electrical
connection (12), but leave the hood disconnected from the home
general electric panel.
In the case that it is decided to use the cooker hood in the suction
version, then place one of the two flanges provided in the exit hole
(13 Suction). Attention! The tall flange should be used when a
telescopic chimney is required to be mounted (this item should be
ordered see special accessories), the short flange is to be used in
all other cases.
Remount the grease filter and the front panels
according to the numbering
noted also on the back of each
screen (from 1 to 4 from the top
to the bottom).
Connect the hood the the home
general electric panel and check
if the hood work properly.