Filter
Top Products
10
Installation
Prepare the hood
NOTE
On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the
hood and decorative flues, prior to final installation.
1. Remove the polystyrene block and the tape (Fig.1).
2. The back plate shown in Fig. 2 must be removed:
remove the (4) screws of the back plate, operating
from the inside of the hood (Fig. 3).
3. Remove the tape on the electrical system plate;
place the electrical system plate on the hood
(protect surface from electrical system plate using
cardboard protection). Fig. 4.
4. Remove the (2) screws of the back plate (Fig. 5)
and discard the back plate.
FIG. 4
ELECTRICAL SYSTEM PLATE
PROTECTION
FIG. 1
FIG. 2
FIG. 3
FIG. 5
POLYSTYRENE BLOCK
TAPE
BACK PLATE