Filter
Top Products
6
Options Selections
Favorite Cycle
The FAVORITE CYCLE option allows you to
program your preferred cycle and options into one
button. Once programmed, simply press the
FAVORITE CYCLE button followed by the START/
CANCEL pad.
To program the FAVORITE CYCLE button:
1) Select your preferred cycle and options
2) Hold the FAVORITE CYCLE button for 3
seconds
The display will flash for 2 seconds indicating the
FAVORITE CYCLE option has been programmed.
To change the FAVORITE CYCLE option simple
repeat steps one and two above.
Wash Pressure
The WASH PRESSURE option allows you to
select the desired wash pressure depending on
your dishload. When MAXX WASH PRESSURE is
selected, the wash pressure is increased by 30%
to provide faster and more effective cleaning.
When LOW WASH PRESSURE is selected, the
wash pressure is decreased by 30% to clean
delicate dishes without damage. MAXX WASH
PRESSURE can be used with all cycles except
RINSE ONLY. MAXX WASH PRESSURE is
automatically provided when MAXX CLEAN or
SPEEDCLEAN cycles are selected. LOW WASH
PRESSURE can be used with all cycles except
SPEEDCLEAN and RINSE ONLY. WASH
PRESSURE may be selected before the wash
cycle is started, or anytime during the wash cycle.
Hi-Temp Wash
When HI-TEMP WASH option is selected, the
dishwasher heats water in the main wash to
approximately 140°F (60°C).
This increase in water temperature helps
dishwasher detergent remove food grease and soil
from dishes more effectively and aids in drying.
This option is available in NORMAL WASH and
PARTY GLASSES. HI-TEMP WASH is automati-
cally provided when MAXX CLEAN cycle is se-
lected.
Sanitize Option
To sanitize your dishes and glassware, select the
SANITIZE option. When selected, the light above
the pad will come on and remain on until end of
cycle. The water temperature in the final rinse will
be raised to 155°F (68°C) assuring bacteria is
destroyed. This option is available in NORMAL
WASH and PARTY GLASSES. SANITIZE is
automatically provided when MAXX CLEAN is
selected. Only these sanitization cycles have been
designed to meet NSF requirements.
The cycle time will be extended until the proper
water temperature is reached.
Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120°F (49°C).
The sanitize criteria may not be satisfied if there is
an interruption of the cycle, power failure or if the
incoming water temperature is below 120°F
(49°C).
To turn off the SANITIZE option, press the pad a
second time. The light above the pad will turn off.
Operating Instructions (continued)