Filter
Top Products
Electric Touch-Control Drop-In Cooktop
E30EC70FSS
High standards of quality at Electrolux Home Products, Inc. mean we are
constantly working to improve our products. We reserve the right to change
specifications or discontinue models without notice.
Electrolux Major Appliances, N.A.
USA
•
250 Bobby Jones Expressway
•
Augusta, GA 30907
•
1-877-4electrolux (1-877-435-3287)
•
electroluxicon.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
electroluxicon.ca
E30EC70FSS 01/09 © 2009 Electrolux Home Products, Inc. Printed in the U.S.A.
30" Electric Touch-Control Drop-In Cooktop Specifications
•
Product Weight – 42 Lbs.
•
Single phase 3- or 4-wire cable, 120/240 or 120/208 Volt,
60 Hertz AC only electrical supply with ground required on separate
circuit fused on both sides of line.
•
Connected Load (kW Rating) @ 240/208 Volts = 7.8/5.9kW
•
Amps @ 240/208 Volts = 33.0/29.0 Amps
•
Recommended Circuit Breaker – 40 Amps
•
Always consult local and/or national electric codes.
•
Allow 2" space below armored cable opening to clear electrical
cable and allow space for installation of junction box on wall at back
of cooktop.
•
Overhead cabinetry should not exceed a 13" maximum depth.
•
Allow 30" minimum clearance between top of cooktop and bottom of
unprotected wood or metal overhead cabinetry.
•
Absolute minimum horizontal distance between overhead cabinets
installed to either side of appliance must be no less than maximum width
of appliance.
•
Allow 24" minimum clearance when bottom of wood or metal overhead
cabinet is protected by not less than 1/8" flame-retardant millboard
covered with not less than No. 28 MGS sheet steel, 0.015" stainless
steel, 0.024" aluminum or 0.020" copper.
•
Allow 1-1/2" minimum clearance between rear edge of cutout and
nearest combustible surface above countertop.
•
Allow 7-1/2" minimum clearance from edge of cooktop to nearest
combustible wall on either side of unit.
•
It is recommended that drawers not be used beneath cooktop.
•
To reduce risk of fire when using overhead cabinetry, install vent hood
that projects horizontally a recommended minimum of 5" beyond bottom
of cabinets.
•
Touch-Control Drop-In Cooktop model E30EC70FSS is approved to be
used over any Electrolux ICON
®
Single Wall Oven. (Refer to Electric
Cooktop Installation Over 30" Electric Single Wall Oven Specifications
page on web.)
•
Touch-Control Drop-In Cooktop model E30EC70FSS is approved to
be used in combination with an Electrolux ICON
®
30” Downdraft Vent.
(Refer to Drop-In Cooktop/Downdraft Vent Countertop Preparation
page on web for detailed installation specifications.)
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxicon.com for detailed instructions.
Optional Accessories
•
Granite Countertop Installation Kit – (PN# 903061-9010).
5" min.
25"min.
13"
max.
cabinet
depth
18"
min.
30" min. for
unprotected cabinet
24" min. for
protected surface
7
1
/2" min. to nearest
combustible wall
(either side of unit)
24"
10"
12"
1
1
/2" min. recommended
distance between rear
edge of cutout and
nearest combustible
surface above countertop
2
1
/2" min. from edge of cutout
to front edge of countertop
20
1
/8" min.
20
1
/4" max.
21
1
/2"
5"
29
7
/8"min.
30"max.
30
3
/4"
30
3
/4"
Approximate location
of junction box
4"x 8" opening to route
armoured cable