Filter
Top Products
46
Using the hood
Important to know
If the hood is run at the same time as a burner or
fireplace that depend on ambient air (for example
gas, Diesel, coal or wood heaters, water heaters,
etc.) be careful, because the hood, when it exhausts
the air, removes the ambient air required by the
burner or fireplace for combustion.
Not valid if the cooker hood is used in
recirculation mode.
A – Motor OFF button
B – ON button and motor speed selection button 1 - 2 - 3 - 1 - 2 - . . . .
E – Speed 1 LED
F – Speed 2 LED and grease filter saturation LED (flashes)
C – Speed 3 LED and carbon filter saturation LED (flashes)
D – Intensive speed indicator LED
G – Intensive speed ON switch
H – OFF lamp button
I – ON lamp button
If the hood fails to operate correctly, briefly disconnect it from the
mains power supply for almost 5 sec. by pulling out the plug. Then
plug it in again and try once more before contacting the Technical
Assistance Service.
The hood has one variable speed motor. For the
best performance, we recommend using the low
speeds in normal conditions and the high speeds in
particular cases of strong odour and vapour con-
centration.
We recommend starting up the hood a few minutes
before cooking and keeping it running until all the
odours have been eliminated.
Intensive speed button
This speed should be used when the concentration
of cooking fumes or odours is particularly strong
(for example when frying, cooking fish etc.).
The fast speed will run for about 5 minutes and
then return to the speed previously set automati-
cally (1, 2 or 3), or switch off if no speed was
selected. To turn off the fast speed, before the end
of the 5 minutes, press button A or button B.
Control devices for the grease filter
and carbon filter
This hood has a device which warns you when to
clean the grease filter or replace the carbon filter
(in the case of the air recircultion version).
Grease filter saturation led
The LED marked F warns you when the grease
filter needs to be cleaned.
This LED flashes to warn you that the grease
filters must be cleaned.
Generally, these must be cleaned after 40 hours of
use.
Read the maintenance instructions provided for the
grease filters.
0 123
5 MIN
0I
FC
BEFCD GAHI
If the hood will be used for recirculation of air, with
carbon filter, the warning signal have to be connected
as follows: Press the buttons B and G at the same
time for about 3 seconds. The LED marked F lights
up. When the LED marked C lights up, the warning
signal is connected.
To disconnect the warning signal, press the buttons
B and G at the same time for about 3 seconds until
the LED marked C goes out.
This hood is delivered without a carbon filter. For
this reason the warning signal to replace the carbon
filter is not connected.