Filter
Top Products
22
BEFORE CLEANING ALWAYS ALLOW
THE COOLING FAN TO COOL THE
APPLIANCE DOWN BEFORE SWITCHING
OFF AT THE ELECTRICITY SUPPLY.
CLEANING MATERIALS
Before using any cleaning materials on your
appliance, check that they are suitable and that their
use is recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Harsh abrasives
should also be avoided.
CLEANING THE OUTSIDE OF THE
APPLIANCE
DO NOT use abrasive cleaning materials e.g. Hob
Brite, Brillo pads or scourers on painted or printed
finishes as damage may occur. Regularly wipe over
the control panel, oven doors and appliance sides
using a soft cloth and liquid detergent. To prevent
streaking on stainless steel models (where
applicable) finish with a soft cloth. Any spillage on
the stainless steel finish must be wiped off
immediately.
Stainless Steel cream cleaners are abrasive and
should be avoided as they may dull the surface
finish.
DO NOT ATTEMPT TO REMOVE ANY OF THE
CONTROL KNOBS FROM THE APPLIANCE AS
THIS MAY CAUSE DAMAGE AND IS A SAFETY
HAZARD.
Under no circumstances should the door
assembly be detached from the product for
cleaning. Please refer to the cleaning
instructions.
CLEANING THE CONTROL KNOBS AND
HANDLES
It is strongly recommended that only hot soapy water
is used for cleaning the control knobs and door
handles. ANY OTHER CLEANING MATERIALS
WILL DULL THE SURFACE FINISH.
CLEANING INSIDE THE OVEN AND
GRILL COMPARTMENT
The vitreous enamel coating in the oven and grill
compartment can be cleaned using normal oven
cleaners or aerosol oven cleaners with care. Ensure
that the manufacturers instructions are followed and
that all parts are well rinsed afterwards.
Aerosol cleaners must not come into contact with
elements or the door seal as this may cause
damage.
CLEANING THE SHELVES, WIREWORK
RUNNERS AND GRILL/OVEN FURNITURE
All removable parts, except the grill pan handle, can
be washed in the dishwasher.
The grill pan, grill pan grid, oven shelves and
wirework runners may be cleaned using a soap
impregnated steel wool pad. Soaking first in hot
soapy water will make cleaning easier.
TO REMOVE THE WIREWORK RUNNERS
The wirework runners in the grill and oven
cavities can be removed for cleaning.
1. Remove all shelves and furniture from the grill
and oven compartments.
2. Hold the wirework at the bottom, unclip from the
cavity side and gently pull towards the centre of
the grill or oven compartment.
3. Unhook the runner at the top and remove from
the cavity.
4. To replace, hook the wirework runner back into
the grill/oven sides.
Ensure that the wirework runners are firmly
in place before refitting the oven shelves.
CARE AND CLEANING
SIDE PANEL
CAVITY CENTRE