Filter
Top Products
19
DO013
600
550
min.
600
Building the appliance in under a worktop
1
1xA
12
1xB
2xC
2
2
1
1
2
1. The dimensions of the recessed installation area
must correspond with those indicated in the figure.
2. Installation kit
3. Two cabinet securing brackets are supplied with
the installation pack. They need to be assembled
onto the cabinet prior to cabinet being pushed into
the Kitchen aperture.
- To fit these brackets remove the two screws at the
top left and right hand front corners of the cabinet.
- Position the two brackets as shown in the figure
and replace the two securing screws.
4. Push the appliance into place. The plug socket
necessary for connection of the appliance to the
electricity supply should be positioned, so that the
plug is not placed in the recess.
5. To adjust the height proceed as follows:
- Loosen or tighten the two front feet.
- The rear feet are adjusted by turning the screw in
the front kick plate to the left or right.
596
555
max
Li89
+
-
2
Left hand
bracket
Right hand
bracket
1/a