Filter
Top Products
Problem Possible cause Solution
Not enough carbon diox-
ide in the water.
The carbon dioxide is running
out.
Refer to "Installation of the gas
cylinder".
Too much carbon dioxide
in the water.
Dilute with ordinary water. Refer to "Selecting and dispens-
ing water".
No carbon dioxide. The gas cylinder is empty. Refer to "Replacing gas cylinder"
No or very low water
flow.
The gas cylinder is empty. Refer to "Replacing gas cylinder".
Sediment in the water. Remove and clean the strainer in
the inlet hose connection.
Water supply obstructed. Check water supply.
Only gas comes out
when dispensing carbo-
nated water.
Water supply obstructed. Check water supply.
Sediment in the water. Remove and clean the strainer in
the inlet hose connection.
The water filter indicator
flashes.
Time out. Refer to "Water filter indicator".
The water filter indicator
lights constantly.
Time out. Refer to "Water filter indicator".
The water dispenser
lamp and the child lock
indicator flashes.
Internal leakage at the water
connection.
Contact your local Electrolux
Service Force Centre.
Dispensing is interrupted
after a short time.
The maximum time of two mi-
nutes is exceeded.
Start new dispensing.
The lamp does not work. The door has been open to long. Close the door.
The lamp is defective. Refer to "Replacing the lamp".
Door interferes with ven-
tilation grill.
The appliance is not levelled. Refer to "Levelling".
Misaligned door.
The appliance is not levelled. Refer to "Levelling".
As much as the advice does not lead to result, call the nearest brand-mark service.
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the light-
ing device. Contact your Service Center .
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
electrolux 13