Filter
Top Products
13
Snap the cover (Hc) onto the guide (Ha).
Open the doors of the appliance and the unit
about 90°. Put the square (B) inside the guide
(A).
Keep the doors of the appliance and unit joined
together and mark the position of the holes as
shown in the figure. Remove the squares and
drill 2-mm holes 3 to 8 mm from the external
edge of the door. Put the square back on the
guide and secure it with the screws included.
Use the slack of the oval holes if the door of the
unit has to be aligned.
Once these operations have been completed,
check that the door of the appliance closes per-
fectly.
Snap the cover (Hd) onto the guide (Hb).
Once the door has been reversed, check that
the magnetic joint adheres to the structure. If
the temperature in the room is too low (in the
winter, for example), it might not adhere per-
fectly. In this case, if you do not want to wait
for the joint to resume its natural size after a
given amount of time, you can speed up the
process by heating the part with a hair dryer.