Filter
Top Products
Electrical
connections
Any electrical work required to install
this appliance should be carried out by
a qualified electrician or competent
person.
WARNING: THIS APPLIANCE MUST
BE EARTHED.
The manufacturer declines any lia-
bility should this safety measure
not be observed.
If the plug that is fitted to your ap-
pliance is not suitable for your socket
outlet, it must be cut off and the appro-
priate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be dispo-
sed of to prevent the hazard of shocks
in case it should be plugged into a
13amp socket in another part of your
home.
Important
The wires in the mains lead are colou-
red in accordance with the following
code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
If you fit your own plug, the co-
lours of the wires in the mains
lead of your appliance may not corre-
spond with the markings identifying
the terminals n your plug, proceed as
follows:
18 electrolux
Connect the Green and Yellow (earth)
wire to the terminal in the plug which is
marked with the letter «E» or the earth
symbol or coloured green and
yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked
with the letter «N» or coloured black.
Connect the brown (live) wire to the
terminal in the plug which is marked
with the letter «L» or coloured red.
The plug moulded onto the lead incor-
porates a fuse. For replacement, use
a 13amp BSI362 fuse. Only ASTA or
BSI approved fuses should be used.
The plug must not be used if the fuse
cover/carrier is lost. The cover/carrier
is indicated by the coloured insert at
the base of the plug.
A replacement cover/carrier must be
obtained from your local Electrolux
Service Force Centre.
This appliance complies with the
E.E.C. Directive No. 87/308 of
2.6.87 relative to radio interference
suppression.