Filter
Top Products
Filling with salt
Only use salt specifically designed for use in
dishwashers.
All other types of salt not specifically designed for use in
a dishwasher, especially table salt, will damage the water
softener.
Only fill with salt just before starting one of the complete
washing programmes.
This will prevent any grains of salt or salty water, which
may have been spilled, remaining on the bottom of the
machine for any period of time, which may cause
corrosion.
To fill:
1. To fill with salt, unscrew the cap of the salt container.
2. Pour 1 litre of water inside the container (this is necessary
only before filling with salt for the first time).
3. Using the funnel provided,
pour in the salt until the
container is full.
Do not worry if water over
flows from the unit when
filling with salt, this is quite
normal.
4. Replace the cap making
sure that there is no trace
of salt on the screw thread
or on the gasket.
5. Screw on the cap tightly.
The salt container will require topping up periodically.
You are reminded of this by the salt indicator light on the
control panel which comes on when the salt has finished.
The salt indicator light on the control panel can remain
illuminated for 2-6 hours after the salt has been
replenished, assuming the dishwasher remains switched
on. If you are using salts that take longer to dissolve then
this can take longer. The function of the machine is not
affected.
From level 2 upwards, if salt refilling is necessary, the salt
indicator light will illuminate only in setting mode and at the
end of the washing programme. During the run of the
programme it will remain off.
Rinse aid
Rinse aid is automatically added during the last rinse,
ensuring thorough rinsing, and spot and streak free drying.
The dispenser, which is positioned inside the door, holds
about 110 ml of rinse aid, which is sufficient for 16 - 40
dishwashing programmes, depending upon the dosage
setting.
Filling with rinse aid
1. Open the container by turning the lid (A) anticlockwise.
2. Add the rinse aid until the container is completely full.
The indicator (B) will be completely dark.
3. Top up the rinse aid when the rinse aid indicator light on
the control panel illuminates.
If rinse aid refilling is necessary, the rinse aid indicator
light will illuminate only in setting mode and at the end of
the washing programme.
During the run of the programme it will remain off.
Ensure that the lid is closed after every refill.
Do not put liquid detergent in the rinse aid compartment.
Clean up any rinse aid spilt during filling with an absorbent
cloth to avoid excess foaming during the next wash.
It is possible to deactivate the rinse aid indicator light (see the
following instructions), By default the rinse aid indicator light is
active.
To deactivate the rinse aid indicator light be
sure that the dishwasher is off and then
proceed as follows:
1. Press Intensive 70° 80’ and Normal 65° programme push
buttons simultaneously.
2. While keeping the programme push buttons Intensive 70°
80’ and Normal 65° pressed switch on the dishwasher by
pressing the On/Off push button.
The On/Off indicator light comes on.
At the same time, the indicator lights of the Intensive 70°
80’ and Normal 65° push buttons start flashing.
3. Press the Normal 65° push button, the correspondent
indicator light keeps flashing while the indicator light of the
Intensive 70° 80’ push button turns off.
At the same time the indicator light "end of programme"
starts to flash.
20
SALE
SALT
SALZ
SEL
SR06
BR01
A
m
a
x
6
5
4
3
2
1
B
BR03
SO406