Electrolux ESF 43010 Dishwasher User Manual


 
daily use electrolux 23
End of the washing programme
The dishwasher will automatically
stop.
The end of programme indicator
light will illuminate.
1. Switch off the dishwasher by
returning the programme knob to
the Off position. The On/Off
indicator light turns off.
2. Open the dishwasher’s door, leave
it ajar and wait a few minutes
before removing the dishes; in this
way they will be cooler and the
drying will be improved.
Unloading the dishwasher
Hot dishes are sensitive to knocks.
The dishes should therefore be
allowed to cool down before
removing from the appliance.
Empty the lower basket first and
then the upper one; this will avoid
water dripping from the upper
basket onto the dishes in the lower
one.
Water may appear on the sides
and the door of the dishwasher as
the stainless steel will eventually
become cooler than the dishes.
When the washing programme has
finished, it is recommended that
the dishwasher is unplugged and
the water tap turned off.
The washing programme or the
countdown of the delay start will
begin only after having pressed
the start/cancel button. Until that
moment it is possible to modify the
selection made.
Interrupt or cancel a washing
programme in progress ONLY if it’s
absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress:
Open the dishwasher door; the
programme will stop. Close the
door; the programme will start from
the point at which it was
interrupted.
Cancel a washing programme in
progress
Press the start/cancel button for
about 5 seconds. The start/cancel
indicator light turns off and the
phase indicator lights are flashing.
The running programme has been
cancelled and it is now possible to
set a new washing programme or
switch off the machine.
If a new washing programme is to
be selected, check that there is
detergent in the detergent
dispenser.
117997 92/0en 5-09-2006 15:18 Pagina 23