Filter
Top Products
36 electrolux installation
Any electrical and/or plumbing
work required to install this
appliance should be carried out by
a qualified electrician and/or
plumber or competent person.
Remove all packaging before
positioning the machine.
If possible, position the machine next
to a water tap and a drain.
Levelling
Good levelling is essential for correct
closure and sealing of the door.
When the appliance is correctly
levelled, the door will not catch on
either side of the cabinet.
If the door does not close correctly,
loosen or tighten the adjustable feet
until the machine is perfectly level.
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop,
you can install it under a close fitting
sink unit or a pre-existing top,
providing the dimensions of the
recess correspond to those shown in
the picture.
Proceed as follows:
● Remove the machine’s worktop by
unscrewing the two rear retaining
screws, pull the worktop from the
back of the machine and slide out
the front slots, lifting the worktop.
Insert the machine after adjusting the
levelling with the adjustable feet.
When inserting the machine, ensure
that the water inlet and drain hoses
are not kinked or squashed.
During all operations that involve
accessibility to internal components
the dishwasher has to be unplugged.
Be sure that once the appliance has
been installed, it is easily accessible
for the service engineer in the event
that a repair is required.
If the dishwasher is later used as a
free-standing appliance, the original
worktop must be re-mounted.
The plinth on free-standing appliances
is not adjustable.
Installation
117988 42/0en 9-02-2007 9:42 Pagina 36