Electrolux ESI Range User Manual


 
Oven Control Style 2 -
Setting the Clock and
Minute Timer
For a silent control panel
(Control Style 2 Only):
When choosing a function, a beep
will be heard each time a pad is
pushed. If desired, the controls can
be programmed for silent operation.
Push and hold STOP TIME for 7
seconds. After 7 seconds, the control
will beep once. This will block the
controls from sounding when a pad
is pushed. To return the sound, push
and hold STOP TIME again for 7
seconds until 1 beep is heard. Note:
The control will return to the audible
mode after a power outage.
Control Style 2
Q
_LOCK QPRE-HEAT
OVEN
To Set the Clock Style 2
When the range is first plugged in, or when the power supply to the range has
been interrupted, the display will flash "12:00".
1. Push _.
2. Within 5 seconds, push and hold(_ or_ until the correct time of day
appears in the display.
Note: The clock cannot be changed during any timed bake or self-clean
cycle.
To Set the Minute Timer Clock Style 2
1. Push _.
2. Push_ to increase the time in one minute increments. Push and
hold_ to increase the time in 10 minute increments. The timer can be
set for any amount of time from 1 minute to 11 hours and 59 minutes.
Note: If you push_ first, the timer will advance to 11 hours and 59
minutes.
3. The display shows the timer count down in minutes until one minute
remains. Then the display will count down in seconds.
4. When the set time has run out, the timer will beep 3 times. It will then
continue to beep 3 times every 60 seconds until_ is pushed.
Note: The minute timer does not start or stop cooking. It serves as an extra
timer in the kitchen that will beep when the set time has run out. The minute
timer can be used alone or during any of the other oven functions. When the
minute timer is in use with any other mode, the minute timer will be shown in
the display. To view other functions, push the function pad for that mode.
To Change the Minute Timer while it is in use:
While the timer is active and shows in the display, push and hold[_ or_
to increase or decrease the time.
To Cancel the Minute Timer before the set time has run out:
Push _.