Filter
Top Products
Alarm code Malfunction
• The programme indicator flashes continuously.
• The end indicator flashes two times intermittently.
The appliance does not drain the water.
• The programme indicator flashes continuously.
• The end indicator flashes three times intermittently.
The anti-flood device is on.
Warning! Deactivate the appliance
before you do the checks.
Malfunction Possible cause Possible solution
The appliance does not fill with
water.
The water tap is blocked or
there is limescale on it.
Clean the water tap.
The water pressure is too low. Contact your local water au-
thority.
The water tap is closed. Open the water tap.
The filter in the water inlet hose
is blocked.
Clean the filter.
The connection of the water in-
let hose is not correct.
Make sure that the connection
is correct.
The water inlet hose is dam-
aged.
Make sure that the water inlet
hose has no damages.
The appliance does not drain
the water.
There is a blockage in the sink
spigot.
Clean the sink spigot.
The connection of the water
drain hose is not correct.
Make sure that the connection
is correct.
The water drain hose is dam-
aged.
Make sure that the water drain
hose has no damages.
The anti-flood device is on. Close the water tap and con-
tact the service centre.
The start of the washing pro-
gramme does not occur.
The appliance door is open. Close the appliance door.
The mains plug is not connec-
ted in the mains socket.
Connect the mains plug.
The fuse in the fuse box is
damaged.
Replace the fuse.
After the check, activate the appliance. The
programme continues from the point of in-
terruption.
If the malfunction occurs again, contact the
service centre.
If the different alarm codes show, contact
the service centre.
The necessary information for the service
centre is on the rating plate.
Record this information:
–Model
(MOD.) ....................................................
....
– Product number
(PNC) ..........................................
– Serial number
(S.N.) ..............................................
The washing results and drying results are not satisfactory
Problem Possible cause Possible solution
The dishes are not clean. The selected washing pro-
gramme was not applicable for
the type of load and soil.
Make sure that the washing
programme is applicable for the
type of load and soil.
electrolux 13