Filter
Top Products
Operating Instructions
30
What to do, if ...
Try to rectify minor faults on the dishwasher with the aid of the
instructions given here. If you call an engineer to resolve a of fault
listed here, or to repair a fault caused by incorrect use or installation, a
charge will be made even if the appliance is in guarantee.
...Error messages
• If the programme indicator for the selected wash programme is
flashing and fault code (1 or (2 is displayed on the multi-display,
you can probably rectify the fault yourself.
After rectifying this fault, press the button for the wash programme
that has been started. The wash programme continues. If the fault
code is displayed again, contact customer service.
• For all other faults, please contact customer service, stating the fault
code.
Symptom Possible Cause Solution
Fault code (1 is dis-
played on the multi-
display.
The programme indica-
tor for the selected
wash programme is
flashing:
there is no water run-
ning into the dish-
washer.
Tap is blocked or furred with
lime-scale.
Clean tap.
The filter (where present) in
the threaded hose fitting is
blocked.
Clean the filter in the
threaded hose fitting.
The water inlet hose is not
correctly laid.
Check hose installation.
Fault code (2 is dis-
played on the multi-
display.
The programme indica-
tor for the selected
wash programme is
flashing.
The sink outlet is blocked. Clean the sink outlet.
The water drain hose is not
correctly laid.
Check hose installation.
Fault code (3 is dis-
played on the multi-
display.
The leak prevention system
has been triggered.
Close the tap and contact
your local AEG Sevice Force
Centre.