Filter
Top Products
31
Adjusting the worktop
You can move the worktop forward or
backward by 25 mm in order to align the
machine with other kitchen units.
Simply unscrew the two rear retaining screws,
move the top to the required position and
then retighten the screws.
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can
install it under a close fitting sink unit or a
pre-existing top, providing the dimensions of
the recess correspond to those shown in the
picture.
Proceed as follows:
- Remove the machine’s worktop by
unscrewing the two rear retaining
screws, pull from the front and slide
out the rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling with the adjustable feet.
When inserting the machine, ensure that the water inlet and drain hoses are not
kinked or squashed.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on the levelling
spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable feet until the
machine is perfectly level.
IN26
820
570 - 600
600
IN05
Installation and connection instructions
IN06
IN07
152980 28/2 8-02-2002 17:20 Pagina 31