Filter
Top Products
Operating Instructions
30
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower rack, an intelligent electronic system adjusts
the amount of water and the duration of the wash programme to the
number of dishes. By this means it is possible to wash only a few dishes
quickly and economically. At half load (6 place settings), up to 2 litres
of water and 0.2 kWh of electricity are saved.
Switching Off the Dishwasher
Switch the dishwasher off when the multi-display indicates "0" for the
remaining programme time.
0 1. Press the ON/OFF button. The ON/OFF button indicator extinguishes.
1
Hot steam may escape from the appliance when opening the door
immediately after the end of the programme.
2. Open the door carefully, as steam may escape.
Emptying the Dishwasher
3
• The dishes should be allowed to cool down before removing them
from the appliance, as hot dishes can be sensitive to knocks.
• Leave the dishes in the dishwasher for approx. 15 minutes after the
end of the programme so that they dry better and can cool down.
• First empty the lower basket, and then the upper basket. This will
avoid any water that may be remaining in the upper basket, dripping
onto the dishes in the lower basket and leaving water marks.
Care and Cleaning
1
Do not under any circumstances use furniture care products or aggres-
sive cleaners.
• If necessary, clean the controls only with a soft cloth and pure warm
water.
• Occasionally check the internal containers, door seal, and water inlet
for soiling, clean if necessary.