Filter
Top Products
24
1. Installation kit
2. Two cabinet securing brackets (D) are supplied
with the installation pack. They need to be
assembled onto the cabinet prior to cabinet being
pushed into the Kitchen aperture.
- To fit these brackets remove the two screws at the
top left and right hand front corners of the cabinet.
- Position the two brackets as shown in the figure
and replace the two securing screws.
Left hand
bracket
Right hand
bracket
2
3. Push the appliance into place. The plug socket
necessary for connection of the appliance to the
electricity supply should be positioned, so that the
plug is not placed in the recess.
To adjust the height proceed as follows:
- Loosen or tighten the two front feet.
- The rear feet are adjusted by turning the screw
in the front kick plate to the left or right.
B
4
1
4. The joint cover (B) is to be assembled after having
installed the appliance in the recess.
1xA
2xD
1xB
2xC
2xL
18xI
2xF
2xG
1xK
1
596
555
max
+
-
3
+
-
max. 890 mm