Filter
Top Products
What to do if...
23
Symptom Possible Cause Remedy
Heavy build up of frost,
possibly also on the door
seal.
Door seal is not air tight
(possibly after reversing
the door).
Carefully warm the leaking
sections of the door seal
with a hair dryer (on a
cool setting). At the same
time shape the warmed
door seal by hand such
that it sits correctly.
The compressor does not
start immediately after
changing the temperature
setting.
This is normal, no error has
occurred.
The compressor starts after
a period of time.
Temperature cannot be set
COOLMATIC or FROSTMAT-
IC functions switched on.
Switch off COOLMATIC or
FROSTMATIC manually, or
wait to set the tempera-
ture until the function has
reset automatically (refer
also to COOLMATIC/FROST-
MATIC section).
Water on the floor or on
storage shelves.
Water drain hole is
blocked.
See the “Cleaning and
Care” section.
There is a function fault.
Please inform your local
Service Force Centre. Do
not open the door of the
appliance again.
Temperature display shows
a square.