Filter
Top Products
16
Control buttons
Control buttons
This hood is equipped with an electronic motor and
lamp control.
The control is able to set 4 diferent fan speeds, turn
ON/OFF light and has a timer function.
In the following drawing are described the main key
functions.
1. Light Button
Press lamp button to turn ON the light (Lamp
state previously OFF).
Press lamp button to turn OFF the light (Lamp
state previously ON).
2. Timer Button
The default timer setting is 10 minutes, and it
can be adjusted between 20 minutes and
1 minute.
After pressing the timer button, the control
enters to a timer setup mode, and user can
adjust the timer countdown time with the
“
” and “ ” buttons within 5 seconds.
The timer can be initiated immediately
pressing the timer button, after setting the
timer duration or pressing the timer button
twice (default 10 minutes setting).
If no action occurs within 5 seconds, the
countdown will start.
During the timer setup the “
” and “ ”
buttons are dedicated to the timer and no
motor action will occur.
Once the timer is initiated, it can be cancelled
by pressing the timer button again.
3. Display
Shows the hood settings.
4. “ ” Button. Speed Decrease/OFF
This button is used to decrease the fan speed,
or turn OFF the fan.
The fan will turn OFF if the “
” button is
•
•
•
•
•
•
•
•
•
•
If the fan is at second speed and the “ ”
button is pressed, the fan will be set to rst speed.
If the fan is at third speed and the “
” key is
pressed, the fan will be set to second speed.
If the fan is at fourth speed and the “
”
button is pressed, the fan will be set to third
speed.
If the fan is OFF and the “
” button is
pressed, the control backlight will light up.
5. “ ” Button. Speed Increase/ON
This button is used to increase the fan speed,
or turn ON the fan.
The fan will turn ON if the “
” button is
pressed and the hood was OFF.
If the fan is at rst speed and the “
” button
is pressed, the fan will be set to second
speed.
If the fan is at second speed and the “
”
button is pressed, the fan will be set to third
speed.
If the fan is at third speed and the “
”
button is pressed, the fan will be set to fourth
speed.
If the fan is at fourth speed and the “
”
button is pressed, a beep will sound.
•
•
•
•
•
•
•
•
•
•