Filter
Top Products
1. Remove the plug from
the power socket.
2. Open the door of the
freezer. Loosen the hinge.
1
2
3
3. Remove the doors by
pulling them slightly and
remove the hinge.
4. On the opposite side,
remove the hole covers.
5. Unscrew both adjusta-
ble feet and the screws of
the bottom door hinge.
Remove the bottom door
hinge and install it on the
opposite side.
6. Unscrew the bottom far
side screw and install on
the opposite side.
7. Unscrew the top door
holding pin.
8. Screw the pin back on
the other side.
3
2
1
9. Fit the doors into the
pins and install the doors.
Install the hinge.
10. On the opposite site,
install the hole covers.
11. Tighten the hinge.
Make sure that the doors
are aligned.
12. Remove and install
the handle
1)
13. Reposition, level the
appliance, wait for at least
four hours and then con-
nect it to the power sock-
et.
1) If foreseen
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.
In case you do not want to carry out the above men-
tioned operations, contact the nearest After Sales Serv-
ice Force. The After Sales Service specialist will carry
out the reversibility of the doors at your cost.
11