Filter
Top Products
Installation
Relocate the door holder pin in
the door holder as per the figure.
Place the door holder pin in the
door at the bottom on the left
side, and fix the door holder with
the screw.
Drive in the two adjustable front
legs, and raise the appliance in
the upright position.
Relocate the door handle from
the left side to the right, and
blind the bore-holes with the
plugs delivered with the
appliance.
To reverse the handle proceed as follows:
Remove screw covers (if fitted)
and handle retaining screws.
Remove blanking plugs on the
opposite side
using a punch.
Relocate the handle to the
opposite side and refit retaining
screws (covers if fitted), and
push
the plastic plugs supplied with
the appliance into the holes
where the handle was previously
fitted.
11