Filter
Top Products
818 35 73-01/6 17
Temperature Display
The temperature display can indicate several pieces
of information.
• During normal operation, the temperature currently present in the
refrigerator (ACTUAL temperature) is displayed.
• When the temperature is being adjusted a flashing display indicates
the fridge compartment temperature currently set (DESIRED temper-
ature).
• If there is a fault in the appliance the temperature display shows a
square or a letter.
ALARM OFF button
With the ALARM OFF button, the acoustic warning signal
can be switched off, e.g. the "Open Door" warning when
sorting in or out, the food to be chilled.
Prior to Initial Start–Up
1
Before connecting the appliance to the mains and putting it into
operation for the first time, leave the appliance to stand for 30 minutes
if was transported upright. After transport on its side, the appliance
must be left to stand for 2 hours before putting it into operation. This is
necessary to allow the refrigerant to flow back into the compressor.
Otherwise the compressor may be damaged.
0 1. Please clean the appliance interior and all accessories prior to initial
start-up (see section: “Maintenance and Cleaning”).
2. The appliance must be correctly installed in accordance with the chap-
ter "Installation" before it is put into operation for the first time. Care
should be especially taken that the mains voltage and frequency avail-
able correspond with the appliance’s rating plate.